Line marking a sports surface, coating a light-traffic tarmac car park, or stopping a concrete floor dusting underfoot. Juno Junosol Water-Based Floor & Driveway Paint - Black is a semi-matt one-pack coating for internal and external work, stocked in 4L and 15L.
Tarmac, asphalt, concrete, masonry and brick are all rated substrates. Being water-based it goes onto asphalt and tarmac without bleed-through, it thins with water, and Juno rate it for poorly ventilated places. Abrasion resistant, anti-dust, and certified Euroclass B-s1, d0 for reaction to fire.
What a tin covers
Practical coverage is 8 m²/L per coat, minimum two coats. That puts the 4L at about 32 m² a coat, roughly 16 m² of finished floor, and the 15L at about 120 m², or 60 m² finished. Absorbent or rough surfaces take more, so order with headroom rather than to the exact square metre.
Preparing the surface
The surface must be firm, dry, rough, absorbent and free of grease, rubber, curing agents and lime-scale. Concrete is sanded or ground to take off laitance and curing agents, then vacuumed; finer or smooth concrete, silica-free slabs included, can instead be etched with 10% hydrochloric acid and jet washed. It also has to make 15 kg/cm² surface tensile strength and over 25 N/mm² compressive. On newly laid asphalt, wait a minimum of 15 days.
Above 10°C: through application and curing.
Relative humidity 80% or below.
Substrate at least 3°C above dew point.
Substrate moisture under 4%, with no rising damp.
No rain or strong wind forecast, and avoid condensation.
Water off it for the first 24 hours.
Laying it on and recoating
Brush, roller or spray all work; brush the first coat where you can, to drive the paint in. If the preparation is in any doubt, test a 1 m² patch for adhesion first. Touch dry is about 1 hour, the minimum recoat 6 hours, and there is no maximum wait between coats.
What it will not do
As supplied it carries no slip-resistance class. Class 3 to UNE-ENV 12633 Annex A comes