General features Vehicle gear mineral oil with very good lubricating, antioxidative, anticorrosive and antifoaming properties. Application Mineral oil intended to lubricate gears of vehicles operating in very difficult conditions, especially for gearboxes and final drives, where API GL-5 oil is recommended, it is featured by perfect properties guaranteeing maximal protection against mechanical wear out. Standards, approvals, specifications Approval for use in the side gear shaft and the housing track frames in the heavy equipment of Huta Stalowa Wola (HSW) Physical and chemical properties Parameters Unit Typical values Quality class according to SAE J 306-OCT 91 - 80W-90 Kinematic viscosity at 100°C mm2/s 14.5 Viscosity index - 99 Flow temperature 0C -30 Solidification point 0C - Ignition temperature 0C 220 Resistance to foaming: · foam volume after 5 min. of air blowing at 25°C/95°C/25°C following the test at 95°C · foam volume after 10 min. standing still at 25°C/95°C/25°C following the test at 95°C ml 10/20/10 0/0/0 Corrosiveness to copper 3 h/120°C, corrosion rate reference sample 2b Lubricating properties on a four ball pressure tester: · weld load, · loaded wear ratio kG 400 56 ATTENTION: Physicochemical parameters listed in the table are typical values. Real values are stated in quality control certificates attached to each product lot.
CharacteristicHipol ® ATF II D mineral oil for automatic car transmission ApplicationHigh quality, mineral oil Hipol ® ATF II D is designed for use in automatic transmissions of cars, trucks and buses, in which the manufacturer recommends the use of Dexron ® II D oil. Hipol ® ATF II D oil is also recommended for use in assistive devices steering systems, in hydraulic clutches of passenger cars and trucks, and in hydraulic systems that require the use of ATF type oils. Standards, approvals, specificationsApprovals: MAN 339 Type Z1 MAN 339 Type V1 ZF TE-ML 04D, 11A, 14A Voith H55.6335xx (G 607) Meets the requirements: GM Dexron® II D GM Type A Suffix A Allison C-4