Chlorinated rubber and pliolite enamels behave differently from ordinary synthetic paint. They flash off fast, and in warm weather they'll skin over before you've laid the coat off properly — leaving brush marks and visible joins in the finish. Juno D-40 is formulated for exactly that problem.
It's built on high boiling point aromatic hydrocarbons. The high boiling point is the important part: the solvent evaporates more slowly than a standard thinner, keeping a wet edge open for longer and giving the film time to flow out level instead of setting with brush marks in it.
What it thins
Chlorinated rubber enamels — swimming pools, plant rooms, floors and marine work.
Pliolite enamels and pliolite-based masonry coatings.
Synthetic enamels, where a slower flash-off is wanted.
It also cleans brushes, rollers and spray equipment after use.
When to reach for it
D-40 earns its place on hot days, on large uninterrupted surfaces where you can't afford a visible join, and on any job where a faster thinner has already given you dry-edge trouble.
The trade-off runs the other way in cold conditions: slower evaporation means longer drying times, so a standard thinner will usually serve better in winter.
Dilute at the rate given in the paint's own data sheet and stir slowly until homogenous. For polyurethane enamels and varnishes, use D-70 instead — D-40 is not formulated for polyurethane systems.
Supplied in 1 litre. Solvent-based — ventilate the work area, wear suitable gloves, and keep away from ignition sources.