The new subwoofer from DALI features a 9” woofer, capable of moving lots of air with power and precision.
The launch of the DALI SUB E-9 F marks a new stage of what is possible at this level of subwoofers!
The new subwoofer from DALI features a 9” woofer, capable of moving lots of air with power and precision. The cone is made from pure aluminium for maximum stiffness and a becoming exterior. Furthermore, the heavy magnet system wields a massive 4-layer, long-stroke voice coil.
All in all, the heavy-duty abilities of this “motor system” ensure that the woofer always follows the signal from the amplifier!
The heart of this subwoofer is the 170W RMS Class D amplifier with a highly linear response. Embracing a classic DALI trademark, it simply acts as a total low frequency extension of your AV system. The result is a powerful, wellbalanced bass reproduction and flawless integration with your speakers. In addition, the integrated limiter helps protecting your subwoofer against overloading.
The back plate of SUB E-9 F features controls for volume adjustment, phase, and upper cut-off frequency, while the power on/off function works automatically via signal detection. And with the options for LFE or LINE inputs, this subwoofer easily accompanies any AV set up.
SUB E-9 F is elevated from the floor by cone shaped rubber feet, while a down-firing bass port allows positioning directly against the wall.
The DALI SUB E-9 F is recommended as compliment to the KUBIK FREE as well as the compact models of the ZENSOR and FAZON series. On top of this it is compatible with all DALI loudspeakers as the perfect completion of a DALI stereo or surround set up.
Speaker Type
Subwoofer
Frequency Range (+/-3 dB) [Hz]
37 - 200
Maximum SPL [dB]
111
Crossover Frequency [Hz]
40 - 120
Low Frequency Driver
1 x 9" long stroke Aluminium
Enclosure Type
Bass Reflex
Bass Reflex Tuning Frequency [Hz]
39.0
Max. Amplifier Power Output [RMS watt]
220
Continous IEC Power Output [RMS wa
Our BMW Sound System Upgrade consists of Front Speakers & Rear Speakers together with sound proofing, a High Powered Amplifier & a boxed Subwoofer.
We supply BMW 1, 2, 3, 4, 5, X1, X3, Series Sound System Upgrades for €2195 including V.A.T and installation.
Please call us on 014971273 and we will happily discuss this product in further detail.
Front & Rear Speaker Upgrade
We upgrade the factory BMW speakers. This consists of a woofer, tweeter and a separate crossover. The crossover separates the frequencies produced by sound into high frequency and middle frequency. The tweeter produces the higher frequencies and it is best suited either high up on the door or around the dash area. The woofer should be placed lower down in the door area. These are installed in the factory locations so nothing is on show.
2-way component system with car-specific upgrade speakers for BMW
Easiest installation due to car-specific baskets and ready-for-use wires
4” / 100 mm midrange and 1” / 25 mm tweeter for the original mounting positions
High-end crossover with reference curve setup
Power RMS / max. 60 / 120 Watts
Frequency response 100 Hz - 25,000 Hz
Impedance 4 Ω
Efficiency 1 W / 1 m 90 dB
Amplifier
This will increase power and also allow you to tune your speakers to your own specification. An amp will also add depth to the sound and give you more control over what you are listening to. The amplifier is quite small and hidden away so you can’t see it at all.
Output power RMS / max.
@ 4 Ohms 4 x 35 / 70 Watts (Font/Rear channels)
@ 2 Ohms 4 x 50 / 100 Watts (Font/Rear channels)
@ 1 Ohm -
bridged @ 4 Ohms -
bridged @ 2 Ohms -
Subwoofer output @ 4 Ohms -
Subwoofer output @ 2 Ohms 1 x 160 / 320 Watts (4 channels each 40 / 80 Watts)
Amplifier technology Class AB
Inputs 4 x High-level speaker input
1x MEC
1 x Remote In
Input sensitivity High-level 5 - 11 Volts
Input impedance RCA / Cinch -
Input impedance high-level 13 Ohms